United States
Q
What is a Cisco MDS 9000 Compatible SFP CWDM transceiver?
A
It is a hot-pluggable small form-factor fiber optic module supporting coarse wavelength division multiplexing, designed for Cisco MDS 9000 series storage switches.
Q
Which CWDM wavelengths are available for this SFP transceiver?
A
It supports eight CWDM channels at 1270 nm, 1290 nm, 1310 nm, 1330 nm, 1350 nm, 1370 nm, 1390 nm, and 1410 nm, each spaced 20 nm apart.
Q
What maximum transmission distance does the Cisco MDS 9000 compatible SFP CWDM support?
A
Over single-mode fiber, it reliably transmits up to 80 km, depending on link budget and fiber attenuation.
Q
What data rates are supported by this CWDM SFP for Cisco MDS 9000?
A
It supports Fibre Channel data rates up to 4.25 Gbps, ensuring high-performance storage networking.
Q
Which fiber type is required for Cisco MDS 9000 Compatible SFP CWDM?
A
Single-mode fiber (SMF) with an LC duplex connector is required for optimal performance.
Q
What connector interface does the CWDM SFP use on Cisco MDS 9000?
A
It uses an LC duplex connector interface, ensuring broad compatibility and easy insertion.
Q
Is the Cisco MDS 9000 Compatible SFP CWDM hot-pluggable?
A
Yes, it supports hot-swapping without powering down the switch, minimizing network downtime.
Q
How do I verify compatibility with Cisco MDS 9000 series switches?
A
Check the switch’s hardware guide or CLI transceiver database; this module is validated for full MDS 9000 interoperability.
Q
How do I install the CWDM SFP on a Cisco MDS 9000 switch?
A
Insert the module into an empty SFP slot, connect LC fiber cables, then verify link status via the switch LEDs or CLI.
Q
What is the typical optical power budget for this CWDM SFP?
A
Typical transmit power ranges from -6 dBm to -3 dBm, receive sensitivity is -23 dBm, yielding a link budget around 17 dB.
Q
How can I troubleshoot link issues with my CWDM SFP?
A
Verify LED status, check fiber cleanliness, confirm correct wavelength pairing, and review switch diagnostics via CLI.
Q
What are the differences between OEM and compatible CWDM SFP modules?
A
OEM modules offer Cisco validation and full vendor support; compatible modules provide the same performance at a lower cost.
Q
What warranty and support come with Cisco MDS 9000 Compatible SFP CWDM?
A
Most suppliers include a one-year replacement warranty and technical support for installation and troubleshooting.
Q
How do I select the correct part number for ordering?
A
Identify your required wavelength channel, data rate, and distance, then reference the corresponding CWDM-SFP-XXXX part code.
Q
What are the environmental specifications for this CWDM SFP module?
A
Operating temperature is 0 °C to 70 °C, storage is -40 °C to 85 °C, and humidity tolerance is 5%–95% non-condensing.
