How do I install the Dell Broadcom 5720 Dual Port NIC?

To install, power down the server, remove the expansion slot cover, insert the NIC into a full-height PCIe 3.0 x8 slot, secure the bracket, power on the server, and install the appropriate drivers via Dell’s support site.

Which operating systems are supported by SKU 540-BBGY?

The 540-BBGY NIC supports Windows Server 2012/2016/2019, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi and other major enterprise OSes; drivers are available on Dell’s Driver Download page.

Does the Broadcom 5720 NIC support link aggregation (teaming)?

Yes. The Dell Broadcom 5720 NIC supports IEEE 802.3ad Link Aggregation Control Protocol (LACP) for port teaming, providing increased throughput and network redundancy across both 1GbE ports.

Can I use SFP modules with the 540-BBGY NIC?

No. The 540-BBGY NIC features fixed RJ45 copper ports only and does not support SFP or SFP+ optical transceivers.

What power consumption can I expect from this NIC?

Under typical load, the Dell Broadcom 5720 Dual Port NIC consumes approximately 4–6 watts, ensuring minimal impact on server power budgets and thermal management.

What management and offload features are included?

The NIC offers TCP/UDP checksum offload, Large Send Offload (LSO), VLAN tagging, flow control, jumbo frames (up to 9 KB MTU), and Energy Efficient Ethernet (EEE) for optimized performance.

Does the Broadcom 5720 NIC support Wake-on-LAN?

Yes. The 540-BBGY NIC supports Wake-on-LAN (WOL), allowing remote boot-up and management of servers over the network when the system is in a low-power state.

What is the maximum MTU size supported by this NIC?

The Dell Broadcom 5720 Dual Port NIC supports jumbo frames up to a 9 KB maximum transmission unit (MTU), improving efficiency for large-packet data transfers.

Are drivers included with the Dell Broadcom 5720 Dual Port NIC?

No physical media is included. Dell provides downloadable drivers and firmware updates for the Broadcom 5720 NIC on its official support website under the NIC’s SKU 540-BBGY.

How does this NIC improve network performance?

By offloading TCP/IP processing, supporting jumbo frames, and enabling link aggregation, the Broadcom 5720 NIC reduces CPU utilization and increases effective throughput, accelerating application performance.

What warranty covers the SKU 540-BBGY Broadcom 5720 NIC?

The Broadcom 5720 Dual Port NIC is covered by Dell’s standard three-year limited hardware warranty, including parts replacement and basic service, with optional on-site and ProSupport upgrades.

Is the Dell Broadcom 5720 NIC hot-pluggable?

No. The NIC is not hot-pluggable; you must power down the server before installing or removing the full-height PCIe adapter to ensure safe handling and hardware integrity.

FEATURED DEAL

Name:

540-BBGY

Description:: Dell Broadcom 5720 Dual Port 1Gigabit Network Interface Card Full Height
Rating:: 4.2(5)
Added to cart 28 times recently
Availability:: In stock - Ready to Ship
Brand:: Dell
GTIN:: 5397063816934
Condition:

3 Year Extended Warranty

Same-day Shipping

14-Day Money Back Guarantee

Shipping:

Payment:

540-bbgy dell broadcom 5720 dual port 1gigabit network interface card full height

3 Year Extended Warranty

Same-day Shipping

14-Day Money Back Guarantee

Need Additional Discount on Product?

Request a quote below - Get Exclusive Pricing and Support.

Shipping:

Payment:

540-BBGY

Dell Broadcom 5720 Dual Port 1Gigabit Network Interface Card...

TRUSTED, TRIED, PROVEN

$5,000,000+

Inventory Delivered By

Officially Accredited

& Verified By

Next-Gen IT

Solutions Powered By

540-BBGY Overview

540-BBGY-Dell Broadcom 5720 Dual Port 1Gigabit Network Interface Card Full Height is a high-performance network interface card designed for server expansion. This expansion card utilizes a PCIe x1 interface with PCIe 3.0 support and is built around the Broadcom 5720 chipset to deliver dual RJ-45 ports with a maximum data rate of 1Gbps per port, ensuring consistent and reliable network connectivity in demanding server environments.

540-BBGY-Dell Broadcom 5720 Dual Port 1Gigabit Network Interface Card Full Height is engineered for compatibility with major operating systems including Windows, Linux, and VMware ESXi while featuring a full height bracket in a form factor optimized for Dell servers. With its passive cooling design, this NIC is ideally suited for network upgrades and server expansion in data centers where reliable operation and seamless integration are critical.

540-BBGY price is is available on request. Get immediate quote.

Request bulk order quote for 540-BBGY for additional pricing. Browse the full Dell Server Modules series or explore all Dell products.

540-BBGY Specifications

Weight: 0.8 lbs
Width: 4.72 inches
Depth: 1.00 inches
PCIe Version: PCIe 3.0
Height: 3.35 inches
Product Type: Expansion Card
Port Count: 2
RAID Levels Supported: N/A
Capture Resolution: N/A
Capture Frame Rate: N/A
Full Height Bracket: Yes
Cooling: Passive
Low Profile Bracket: No
Operating System Compatibility: Windows / Linux / VMware ESXi
Bus Width: N/A
Power Requirements: N/A
Max Data Rate: 1Gbps
Card Type: Network Interface Card
Use Case: Server Expansion
Interface: PCIe x1
Chipset / Controller: Broadcom 5720
Supported Ports: RJ-45
Product Name: 540-BBGY-Dell Broadcom 5720 Dual Port 1Gigabit Network Interface Card Full Height

540-BBGY Use Case

Redundant Uplink for Enterprise Data Centers

In a mission-critical enterprise data center, IT teams install the 540-BBGY Dell Broadcom® 5720 Dual Port 1 Gigabit Network Interface Card Full Height in rack-mount servers to create mirrored uplinks. By configuring port-channel failover with Broadcom ADV® features, businesses achieve seamless link redundancy and sub-second switchover. Outcome: maximized network uptime, consistent throughput under load and compliance with strict SLA requirements.

VMware vSphere Network Teaming in Virtualized Servers

A virtualization architect integrates the Dell Broadcom 5720 Dual Port 1 Gigabit NIC (540-BBGY) into Dell PowerEdge hosts to enable 802.3ad LACP link aggregation for VMware vSphere clusters. This setup spreads VM traffic across two physical ports, leveraging Broadcom offloads and jumbo frames for optimal packet handling. Outcome: improved VM network throughput by up to 1.8×, balanced load distribution and reduced latency for multi-tenant environments.

iSCSI Storage Traffic Optimization in Hyperconverged Systems

In a hyperconverged infrastructure deployment (e.g., Dell VxRail), storage architects assign one port of the 540-BBGY Broadcom 5720 Dual Port NIC to iSCSI traffic and the other to management VLANs. By isolating storage I/O, enabling Jumbo Frames and iSCSI offload, the card delivers low-latency packet processing. Outcome: up to 30% faster VM disk I/O, streamlined storage paths and predictable performance for virtual workloads.

Quality Certifications

To get the detailed certification, please go to the Compliance Center.

Product Comparison Table

	540-BBGY	400-AKWU	Dell Server Interface Module	400-AJRX	0W0VNC
Product Type	Expansion Card	N/A	Expansion Card	Hard Drive	N/A
Card Type	Network Interface Card	Other	Network Interface Card	N/A	N/A
Interface	PCIe x1	N/A	PCIe x4	N/A	N/A
PCIe Version	PCIe 3.0	N/A	PCIe 4.0	N/A	N/A
Chipset / Controller	Broadcom 5720	N/A	N/A	N/A	N/A
Supported Ports	RJ-45	N/A	SFP+	N/A	N/A
Port Count	2	N/A	2	N/A	N/A
Max Data Rate	1Gbps	N/A	10Gbps	N/A	N/A
RAID Levels Supported	N/A	N/A	N/A	N/A	N/A
Capture Resolution	N/A	N/A	N/A	N/A	N/A
Capture Frame Rate	N/A	N/A	N/A	N/A	N/A
Low Profile Bracket	No	No	Yes	No	No
Full Height Bracket	Yes	No	Yes	No	No
Cooling	Passive	N/A	Passive	N/A	N/A
Operating System Compatibility	Windows / Linux / VMware ESXi	N/A	Windows / Linux / VMware ESXi	N/A	N/A
Bus Width	N/A	N/A	64-bit	N/A	N/A
Power Requirements	N/A	N/A	3.3V	N/A	N/A
Use Case	Server Expansion	Storage Expansion	Server Expansion	Storage Expansion	Storage Expansion
Product Name	540-BBGY-Dell Broadcom 5720 Dual Port 1Gigabit Network Interface Card Full Height	400-AKWU-Dell 8TB 7.2K RPM SATA 6Gbps 512e 3.5in Drive	Dell Server Interface Module-Dell Server Interface Module - TAA compliant	400-AJRX-Dell 300GB 15K RPM SAS 12Gbps 2.5in Hot-plug Drive 3.5in Hybrid Carrier	0W0VNC-Dell 0W0VNC 1TB 7200RPM SATA-6Gbps 512N 128MB Buffer 3.5inch Enterprise Hot-Plug Hard Disk Drive with Tray For 13G PowerEdge Server
Height	3.35 inches	1 in	1.0 inches	1.02 inches	1 in
Width	4.72 inches	5.79 in	3.0 inches	5.77 inches	5.79 in
Depth	1.00 inches	4 in	8.0 inches	8.00 inches	7.25 in
Weight	0.8 lbs	1.5 lbs	1.2 lbs	1.20 lbs	1.8 lbs

Reviews & Ratings

Kevin Armstrong

Network card installed easily and works as expected.

Hammad Rafi

Stable connectivity for office servers.

Lukas Brandt

Reliable dual port performance.

Sameer Khan

No driver issues encountered.

Charles Newton

Solid NIC for standard networking needs.

Questions & Answers

What is the Dell Broadcom 5720 Dual Port 1Gigabit Network Interface Card (SKU: 540-BBGY)?

The Dell Broadcom 5720 Dual Port 1Gigabit Network Interface Card (SKU: 540-BBGY) is a full-height PCIe adapter providing two 1GbE RJ45 ports based on the Broadcom 5720 chipset, delivering reliable wired connectivity and advanced networking features for Dell PowerEdge servers.

Which Dell servers support the 540-BBGY Broadcom 5720 NIC?

The 540-BBGY Broadcom 5720 NIC is certified for Dell PowerEdge 12th, 13th and 14th generation servers, including R630, R730, R740, T630, T640 and similar platforms with available full-height PCIe slots.

What interface and form factor does the Broadcom 5720 NIC use?

The Broadcom 5720 NIC uses a PCIe 3.0 x8 interface in a full-height, half-length form factor, ensuring compatibility with standard server chassis and optimal bandwidth for 1GbE connectivity.

What network speeds does the Dell Broadcom 5720 NIC support?

This NIC supports two independent 1 Gigabit per second Ethernet ports (1GbE), offering up to 2 Gbps aggregate bandwidth for data transfer and network-intensive applications.

Related Searches Dell Server Modules

Dell Server Interface Module 0W0VNC 400-AFMX 400-AJRX 400-AKWU

540-BBGY Overview

540-BBGY price is is available on request. Get immediate quote.

Request bulk order quote for 540-BBGY for additional pricing. Browse the full Dell Server Modules series or explore all Dell products.

540-BBGY Specifications

Weight

0.8 lbs

Width

4.72 inches

Depth

1.00 inches

PCIe Version

PCIe 3.0

Height

3.35 inches

Product Type

Expansion Card

Port Count

RAID Levels Supported

N/A

Capture Resolution

N/A

Capture Frame Rate

N/A

Full Height Bracket

Yes

Cooling

Passive

Low Profile Bracket

Operating System Compatibility

Windows / Linux / VMware ESXi

Bus Width

N/A

Power Requirements

N/A

Max Data Rate

1Gbps

Card Type

Network Interface Card

Use Case

Server Expansion

Interface

PCIe x1

Chipset / Controller

Broadcom 5720

Supported Ports

RJ-45

Product Name

540-BBGY-Dell Broadcom 5720 Dual Port 1Gigabit Network Interface Card Full Height